KWM-380 カタログ |
||||||||
|
||||||||
Rockwell-Collins Model: KWM-380 HF-380 HF帯 ゼネラルカバレッジ トランシーバー: 1979 年 9 月発表: Scope: KWM-380 HF-380: 回路はオールソリッドステート化。受信部は、高周波増幅回路が無く、直接 DBM で周波数変換、第一中間周波数 39.145MHz, 第二中間周波数は 455KHz、局発( 6.71MHz +- 2.85KHz ) との間で 6.25MHz を得て、可変 PassBand Tuning をしている。当時としては画期的な Up-Coversion method を採用。 ファイナルは Motorola 社の MRF421 をプッシュプルで採用、出力 100 watts を得ている。局発は PLL 回路方式採用、バンド 切替スイッチは無く、 MHz - KHz - 100Hz - 10Hz の四つのスイッチで選択して周波数を設定。 主な仕様: 受信周波数: 500KHz - 30MHz 送信周波数: 1.6MHz - 30MHz (= KWM-380 はハムバンドのみ) < 10Hz step > < 500KHz - 1.4MHz は受信感度 30dB attenuated > 寸法: 394mm (W) x 165mm (H) x 457mm (D) 重量: 21.8 Kgs (48lbs) 電源: 105 - 115 - 125 - 210 - 220- 230 - 240 - 250V AC or 12 - 15V DC 受信モード: USB LSB AM and CW 送信モード: USB LSB CW 感度: 0.5μV or better for 10dB (s+n) for 2.0MHz - 30.0MHz 感度: 1.0μV or better for 10dB (s+n) for 1.8 - 2.0MHz 選択度: 3-dB minimum: 8KHz 2.1KHz Optional Filters: 6KHz AM (特に昨今のノイズの多い時代、快適な BCL を保証)。 3KHz SSB (表示は 2.8KHz) 素晴らしい音です ! 1.7KHz RTTY 500Hz CW 360Hz CW 200Hz CW 140Hz CW IF and Image Rejection: Greater than 60dB 送信出力: 100 watts pep, nominal. 不要輻射: Carrier: -50dB or better. 不要サイドバンド: 1KHz ref. -55dB 高調波: -40dB or better. 第三次歪: 25dB below. デジタルシンセサイザー精度: Plus or Minus 5Hz 以内。 (通電後 10 分) その他主な Options: 冷却ブロアーキット。 Speech Processor。 Noise Blanker。 Kiron Memory Board。 |
||||||||
|
||||||||
KWM-380 HF-380 * SPECIFICATIONS: Parameter Specifications Physical Size 394 mm (15.5 in.) wide; 190 mm (7.5 in.) high, inc. 25 mm (1 in.) feet; 457 mm (18.0 in.) deep. Weight 27.2 kg (50 Lb.), max Environmental Operating temperature 0 to 50C (32 to 122F) Operating humidity 0 to 90% relative humidity Operating altitude 0 to 3049 m (0 to 10,000 ft.) Vibration 2 g's, 10 to 33 Hz Electrical Primary power Strappable for: 105,115,125/210, 220, 230, 240, 250 V + 5%, 50 to 60 Hz; or 12 to 15 V dc, negative ground:120 watts max in receive, 600 watts max in transmit Receiver Frequency 0.5 to 30.0 MHz, tunable in 10 Hz steps Modes u.s.b., l.s.b., a.m..and c.w. Sensitivity (Soft uV 0.5 pV or better for 10 dB (s+n)/n, 2.0 to 30.0 MHz, measurement) s.s.b. and c.w.; 1.0 uV or better for 1.8 to 2.0 MHz. Selectivity (3 dB Selectable bandwidth) 8 KHz *6 KHz * 3KHz (for HF-380 "Special") 2.1 KHz *1.7 KHz *500 Hz *360 Hz 2.1 kHz *140 Hz (*Optional Filters) I.F. and image rej Greater than 60 dB Intermod distortion -50 dB or better for two signals of -10 db mW each, 20 kHz apart AGC Audio output variation not more than 8 dB for 4 uV to 200 mV open circuit r.f. input variation Audio output Not less than 3 W into 4 ohm load, at 1 kHz, at not more than 10% total harmonic distortion Line audio output not less than -10 dB mW nominal in to 600 ohms Frequency response: 300 to 2400 Hz with not more than 5 dB variation Transmitter (HF-380): From 1.6MHz continuously thru 30MHz, in 10Hz steps. Transmitter (KWM-380): Frequency 160 through 10 m amateur bands, in 10 Hz steps 160 m 1.800 to 2.000 MHz 80/75 m 3.500 to 4.000 MHz 40 m 7.000 to 7.300 MHz 20 m 14.000 to 14.350 MHz 15 m 21.000 to 21.450 MHz 10 m 28.000 to 29.700 MHz Modes u.s.b., l.s.b., and c w. (RTTY by AFSK on l.s.b.) Output power 90 W pep, min (100 W, nominal) In c.w. or RTTY: 50% duty cycle; key down 15 minutes, max. Automatic turndown to 50 W after 10 seconds. With optional blower kit installed, power is 100 W average, 50% duty cycle, key down 1 hour max at 25C; 30 minutes max at 50・C for all modes. Unwanted sig suppression Carrier -50 dB or better Undesired sideband, 1 kHz ref -55 dB or better Harmonics (all) -40 dB or better Mixer products -50 dB or better Third order distortion 25 dB below each tone of 2-tone test Synthesizer accuracy Accuracy within + 5 Hz after 10 minutes warmup when and stability 39.6 MHz and 455 kHz oscillators are set to within +/- 3 Hz. Stability within +150 Hz over temperature range of 0 to 50C (32 to 122F) if oscillator's set within 10 Hz at 25 C (77 F) Antenna Impedance 50 ohms, nonreactive. (Full transmitter power output with v.s.w.r. of 2:1 or less. Automatic power output turndown with v.s.w.r. greater than 2:1.) Audio inputs Microphone Low or high impedance, dynamic; 3.3k nominal impedance Line 600 ohm, unbalanced; 40 mV input sufficient for full r.f. power output |